14. Attach the antenna with the black core [1] to the front pad.
15. Attach the antenna with the white core [2] to the rear pad.
• The antenna with the black core transmits and receives. It must be installed at the front.
• The antenna with the white core only receives. It must be installed at the rear.
16. Peel the seal from a clamp, close the clamp around the cables at [3], and attach the clamp to the
cover.
17. Attach then next clamp [4] 15 cm below the antennas.
18. Attach the last clamp [5] 5 cm below clamp [4].
19. Confirm that the cables are not covering any part of the ventilation port [6].
20. Confirm that the cables are not crossed.
• Cable with the black core to the antenna at the front.
• Cable with the white core to the antenna at the rear.
• To assure reliable data sending and receiving, the antenna with the black core must be
installed at front, and the antenna with the white core at the rear.
MFP Options
199
To Next Page
Loading...
