Black Mylars
1. Remove the right copy tray [1] (x2).
2. Remove the left copy tray [2] (x2).
3. Turn over both copy trays.
4. Remove the tape [3] from the edge closest to the hole.
5. With its sticky side facing down, set the hole in the mylar over the hook [1], align it with the top edge,
then press down.
6. Remove the second tape [2] from the bottom.
7. Press down on the bottom edge [3].
8. Make sure that the top and bottom edges of the mylar are both flat.
9. Attach the second mylar to the underside of the other copy tray.
Scanner Separation Unit Type 7140 (D436)
251
To Next Page
Loading...
