10. Reattach the copy trays.
11. Check the holes and make sure that the mylars are snug and cover the holes completely.
• These mylars prevent light from entering the development unit.
Table Leveling
1. Rotate the leveling shoes with your fingers until they touch the floor.
2. With at least three casters touching the floor (¬, Á, ®), make sure that the 4th caster is not floating
more that 5 mm above the floor.
3. Tighten the lower nut [1] until it is snug.
4. Tighten the upper nut [2] to fix the position.
Reinstallation
Follow these instructions in reverse order to reattach:
• Scanner cover
2. Installation
252
To Next Page
Loading...
