3. Set the lever [1] to the left to release the blade from the drum.
4. Remove:
[1] Drum unit left side ( x 1, spring x 1, bushing x 1)
[2] Drum unit right side ( x 1, spring x 1, bushing x 1)
[3] OPC drum
[4] Rubber plates
• When installing a new drum, remove both rubber plates inside the old drum and install them in
the new drum. (These plates reduce the noise caused by inertia when the drum starts and stops.)
4. Replacement and Adjustment
308
To Next Page
Loading...
