2. Remove the accessories [A] from the back of the machine.
3. Remove all tape and shipping materials.
• Keep the shipping retainers after installing the machine. They will be reused if the machine is
moved to another location in the future.
The position of the operation panel can be adjusted to reduce reflection on the operation panel
display.
4. If you want to adjust the position, remove the screws ( x3).
5. Raise or lower the operation panel [1] to one of the three sets of holes.
6. Push each screw [2] into its hole ( x3). (These screws do not need to be tightened.)
7. Pull out the upper tray.
8. Take out the four paper holders and remove their tapes (x 2 each).
2. Installation
30
To Next Page
Loading...
