Initializing the Developer
• Do not do this procedure until you have entered the Lot Numbers. See the previous section.
1. Go into the SP mode.
2. Enter 2801 001 and press [#].
3. When the message prompts you to proceed, touch "Yes".
4. Push [Execute]. Wait for about 2.5 min.
5. When the message tells you that the operation is finished, touch "Exit".
6. Touch "SP Direct", then use the 10-key pad to enter 2923 001 and push [#].
7. Push [Execute]. The machine enters the drum set mode and dusts the drum with toner.
8. When the message prompts you that the operation is finished, touch [Exit].
9. Open the upper unit [A] and confirm that the drum is covered with toner.
10. Push the pressure lever [B] to the right to push the cleaning blade against the drum, then close the
upper unit.
11. To initialize the ID sensor, touch "SP Direct", push [#], enter SP3001 002 then touch [Execute]. Wait
about 6 seconds for initialization to complete.
12. When the message prompts you that the operation is finished, touch "Exit".
Main Machine (D046/D049)
37
To Next Page
Loading...
