Enable NIB and USB
The Ethernet NIB and USB are built in but must be enabled.
1. Do SP 5985 (the default is ‘disabled’).
• 001: Onboard NIC (Ethernet NIB)
• 002: Onboard USB
2. Exit the SP mode.
Sample Copies
1. Load some roll paper in the machine.
• For loading instructions, see the decals on the top edge of the roll feeder front cover.
2. Make some copy samples.
Emblem Panel: Brand Set D046 or D049
1. Attach the emblem to the original feed unit cover.
• Push the panel in until the emblem and panel move into their positions with an audible click.
2. Installation
38
To Next Page
Loading...
