2. Measure the side-to-side registration.
Standard 5±2.0 mm
3. Adjust side-to-side Registration for each paper feed station if necessary.
SP Name
1002-1 Side-to-Side Registration - 1st Roll
1002-2 Side-to-Side Registration - 2nd Roll
1002-3 Side-to-Side Registration - 3rd Roll/1st Cassette
1002-4 Side-to-Side Registration - 4th Roll/2nd Cassette
1002-5 Side-to-Side Registration - By-pass feed
(5) Restoring the Printing and Scanner Erase Margin Setting
1. Restore the SP codes listed below to their original settings. (Refer to the SMC list printed earlier).
SP Name Setting
2101-1 Printing Erase Margin – Leading Edge 5 to 2 (default)
2101-3 Printing Erase Margin – Left Edge 5 to 2 (default)
4012-5 Scanner Erase Margin – DF Leading Edge 0 to 1.5 (default)
4012-7 Scanner Erase Margin – DF Left 0 to 1.5 (default)
(6) Printer/Scanner Magnification
1. Copy an OS-A-1 Test Chart with plain paper (cut sheet or roll).
2. Measure the length and width of the image on the original and the copy.
Standard Less than ± 0.5 %
3. If the measurements do not meet the standard, adjust the following SP codes.
SP4101-1 Scanner Main Scan Magnification
SP4008-1 Scanner Sub Scan Magnification
Important Adjustments
419
To Next Page
Loading...
