(7) Printer/Scanner Leading Edge Registration
1. Copy an OS-A-1 Test Chart with plain paper (cut sheet or roll).
• Make sure that you execute the copy with manual density set at the operation panel.
• Measure the leading edge registration.
Standard Within ±3.0 mm
If the measurement does not meet the standard, adjust the following SP code.
SP4010 001 Scanner Sub Scan Registration Leading Edge
(8) Printer/Scanner Side-To-Side Registration
1. Copy an OS-A-1 Test Chart with plain paper (cut sheet or roll).
• Make sure that you execute the copy with manual density set at the operation panel.
• Measure the side-to-side registration, within 50 mm from the leading edge of the copy.
Standard Within ±2.8 mm
If the measurement does not meet the standard, adjust the following SP code.
SP4011 001 Scanner Main Scan Registration
(9) Printer Cut Length Adjustment
1. Using the Preset Cut feature, make standard cuts of plain paper for A4 sideways, A3 sideways, A1
lengthways, and A0, A sideways, B sideways, D lengthways, and E.
2. Measure the cuts and check them against the standards in the table.
Range Plain Translucent/Film
Up to 297 mm Less than ±2 mm Less than ±3 mm
298 - 800 mm Less than ±3 mm Less than ±4.5 mm
801 - 1189 mm Less than ±4 mm Less than ±5 mm
1190 - 2500 mm Less than ±7 mm Less than ±9 mm
4. Replacement and Adjustment
420
To Next Page
Loading...
