2501 - 3600 mm Less than ±11 mm Less than ±13.5 mm
3601 - 6000 mm Less than ±20 mm ---
6001 - 15000 mm Less than –32 to +200 mm ---
15001 – 30000 mm Less than –32 to +400 mm ---
3. If a measurement does not meet the standard, then adjust the following SPs for each roller and paper
type.
Upper Tray
SP1920-21 to 33 Cut Length Adjustment – 1st Roll: Plain
SP1920-41 to 53 Cut Length Adjustment - 1st Roll: Translucent
SP1920-61 to 73 Cut Length Adjustment – 1st Roll: Film
SP1920-81 to 93 Cut Length Adjustment – 2nd Roll: Plain
SP1920-101 to 113 Cut Length Adjustment - 2nd Roll: Translucent
SP1920-121 to 133 Cut Length Adjustment - 2nd Roll: Film
Lower Tray
SP1920-141 to 153 Cut Length Adjustment – 3rd Roll: Plain
SP1920-161 to 173 Cut Length Adjustment – 3rd Roll: Translucent
SP1920-181 to 193 Cut Length Adjustment – 3rd Roll: Film
SP1920-201 to 213 Cut Length Adjustment – 4th Roll: Plain
SP1920-221 to 233 Cut Length Adjustment – 4th Roll: Translucent
SP1920-241 to 253 Cut Length Adjustment – 4th Roll: Film
(10) Printer/Scanner Trailing Edge Registration (Synchro-Cut)
1. Prepare two originals. One must have length 210 mm, and the other must have length 1000 mm.
2. Make a copy of each original with plain paper in the synchro cut mode.
3. Measure the cuts and check them against the standards in the table.
Range Plain Translucent/Film
Important Adjustments
421
To Next Page
Loading...
