Source Width (mm) Range Default Step (mm)
42 400
110
1st Roll
299
-5 to +5 0 0.1111 440
112 600
120
2nd Roll
299
-5 to +5 0 0.1121 440
122 600
130
3rd Roll
299
-5 to +5 0 0.1131 440
132 600
140
4th Roll
299
-5 to +5 0 0.1141 440
142 600
1918
Fusing/Registration Motor Speed Change DFU
The machine stretches the paper between the registration roller and fusing roller by running
the fusing/exit motor at a speed slightly higher than that of the registration motor. This "stretch-
transport" method prevents long sheets from skewing and wrinkling. However, this stretching
can also affect the rate of magnification. magnification.
• To compensate for this, these SP codes change a shift in speed and timing control.
• These settings are done for three variables: paper type, paper width, feed station.
• Up to three shifts during the printing of one sheet is possible, but normally there is only
one shift per sheet.
SP1918 Settings Table
Source Event Type Width
10
Roll 1st Chg Timing Plain
> 611
[132-3200/170/1 mm]
11 461-610
8. Appendix: SP Mode Tables
90
To Next Page
Loading...
