490
1
Scan Correction DFU
Adjusts the AEREF (Automatic Exposure Reference) setting used for shading correction processing
during image scanning and shading data output.
1
Shading Correction: AEREF Setting
[0 to 63/0/1]
Set a low value for weak background erase, a high value for stronger background erase.
2
Shading Correction: Shading Data Output
[0 to 4095/4000/1]
This SP displays and sets the coefficient for shading correction of scanned images.
3
Digital AE: AEREF Correction
Changes the level for background erase (AEREF value) that is used in the digital A/E processing
of the scan data.
[-63 to +63/0/1]
4
Digital AE: Low Limit
Defines the lower limit of the background erase level that is used in the digital A/E processing
of the scanned data.
[0 to 255/82/1]
5
Digital AE: Start Position
Changes the starting point for digital A/E processing of the scanning data.
[0.5 to 10.0/3/0.1 mm]
Note: The starting position specified with the scanning application takes priority over this setting.
6
Digital AE: Left Start Position
This SP sets the start position for digital AE processing P-Wind for scanned image data in the main
scan direction (from the center of the orignal as a reference point), starting at the left side of the
original.
[0 to 512/60/0.1 mm]
7
Digital AE: Right Start Position
This SP sets the start position for digital AE processing P-Wind for scanned image data in the main
scan direction (from the center of the orignal as a reference point), stopping at the right side of
the original.
System Service Mode
147
To Next Page
Loading...
