21
ECS
Initializes the ECS settings.
5802
Engine Free Run
Makes a base engine free run.
Note: The machine automatically leaves free run mode after the machine leaves the SP mode
or after the machine is cycled off and on.
[0 to 1/1]
0: Disable: Release free run mode
1: Enable: Enable free run mode
5803 Input Check
Allows you to test component input. For details see "Input Check" in the "Appendices".
5804 Output Check
Allows you to test component output. For details see "Input Check" in the "Appendices".
5810 SC Reset DFU
When the machine issues one of the "Level A" SC codes shown below, this indicates a serious
problem in the fusing unit. The machine is disabled and the operator cannot reset the SC.
The machine requires servicing immediately. Touch [EXECUTE] release the machine for
servicing.
• SC542 – SC545 Heating roller thermistor 1
• SC547 – Zero Cross
• SC548 – SC550 Heating roller thermistor 2
• SC551 – Pressure roller thermistor
• SC553 – SC555 Pressure roller thermistor
• SC662 – SC565 Hot roller thermistor
5811 Machine Serial Number GW
The serial number is set with this code before shipping.
8. Appendix: SP Mode Tables
164
To Next Page
Loading...
