5812 Service Tel. No. Setting GW
1 Service
Inputs the telephone number of the CE (displayed when a service call
condition occurs.)
2 Facsimile Input the fax number of the CE.
3 Supply
These SP codes allow you to enter the telephone numbers to be displayed
for the supply and operation support centers in the User Tools mode.
4 Operation
5816 Remote Service GW
1 I/F Setting
Selects the remote service setting.
[0 to 2 / 2 / 1 /step]
0: Remote service off
1: CSS remote service on
2: @Remote service on
2 CE Call
Performs the CE Call at the start or end of the service.
[0 or 1 / 0 / 1 /step]
0: Start of the service
1: End of the service
NOTE: This SP is activated only when SP 5816-001 is set to “2”.
3 Function Flag
Enables or disables the remote service function.
[0 to 1 / 0 / 1 /step]
0: Disabled, 1: Enabled
NOTE: This SP setting is changed to "1" after @Remote registor has been completed.
6 Device Information Call Display
Controls if the item for initial setting of the screen for the NRS device-information notification-
call is shown.
[0 to 1/1]
0: Enabled. Item initial setting not shown.
System Service Mode
165
To Next Page
Loading...
