3. Attach the small harness clamps (x4) [A] to the holes (À, Á, Â, Ã) on the left side of the frame inside
the drawer.
4. Attach the small bushing [B] to the hole.
5. Insert the small end of the heater harness [C] through the grommet and pull it to the front.
6. Close the harness clamps on the harness.
7. At the left rear corner, attach the small harness clamp [A] ( x1).
Paper Cassette Type 7140 (D395)
69
To Next Page
Loading...
