8. Open the harness clamps ( x2).
9. Separate the connectors [B] to provide connection points for the harness.
10. Connect the heater harness [C] ( x2).
11. Push the heater harness through the hole [D] to remove slack.
12. Close the harness clamps ¬, Á, ® ( x3).
Interface Harness
1. At the right rear corner, attach the large bushing [A].
2. Thread one end of the interface harness [B] through the hole.
• The white/gray connector pair [C] is at the front end of the cable.
3. Attach one large harness clamp [D] to the right frame inside the drawer, then close the clamp around
the cable.
2. Installation
70
To Next Page
Loading...
