Drum
SM 4-59 C279
and
Adjustment
Installation
Do not scratch the cloth screen or metal screen.
Properly insert the edge of the belt cloth [A] on the cloth screen under the mylar [B] on the
metal screen, as shown above. Otherwise, ink will leak from the trailing edge of the master on
the drum during a long printing run.
Make sure that the correct side of the screen is facing up. In addition, make sure that the
stays for securing the cloth screen are positioned correctly. (Refer to the upper right
illustration.)
When replacing the cloth screen, spread the screen around the metal screen while strongly
pulling the stay [C]. Adjust the stay so that it is parallel to the master clamper, then tighten the
screws.
Make sure that the cloth screen is not wrinkled while spreading it around the drum.
To Next Page
Loading...
