Ricoh DD 4450 - Network Controller Installation: Board Preparation

Network Controller (C654)
C279 2-28 SM
2.7.2 INSTALLATION PROCEDURE
Prepare to install the board: Stage 1
1. Attach the three brackets [A], [B], [C] (
×3).
2. Install the clamps [D] (
× 3).
3. Attach the harness [E] (
× 2, × 1).
Prepare to install the board: Stage 2
1. Check whether the “mm/inch” setting in the User Tools (System – mm/inch) is set to the
correct value. If necessary, change it to the correct “mm/inch” setting.
2. Check whether “SP2-7” (Vendor Selection) is set to the correct value. If necessary, change it
to the correct vendor setting. (
Appendices – Main SP Tables)