Ricoh DD 4450 - Installation Procedure

Tape Dispenser (C651)
C279 2-24 SM
2.6.2 INSTALLATION PROCEDURE
1. Turn off the main switch and unplug the power cord.
2. Remove the paper delivery plate.
3. Install the auxiliary bracket [B] on the tape dispenser[A] with M4 x 8 screws (accessories).
4. Cut off the cover [C] in the rear cover, as shown.
5. Remove the connecter cover [D].
6. Remove the screw that is beside the connector [E].
7. Install the tape dispenser on the main body with two knob screws (accessories) in the two
outer holes in the tape dispenser bracket.
 Install the lock washer (accessories) with the lower of the two knob screws.
 Tighten the knob screws with a screwdriver to prevent them from coming loose.
8. Reinstall the paper delivery plate.