SP Table
SM Appendix 9 C279
Appendix:
Service
Program
Mode Tables
Brands depend on the destination.
*1 Displays only brand that can be set.
RICOH / TTEC / KMBJ / NRG / Nashuatec /RexRotary / Gestetner / Lanier /
Savin / Standard
*2 If the model code has not been set, if there are multiple brands of a single
model code, "RICOH" has been set.
2-10
Ink detection board
[ ON-OFF / ON / -]
Sets whether to detect the ink in the drum.
ON: Detect the ink.
OFF: The ink is considered always exist.
("OFF" is used in the test or if the ink be removed from the drum..)
2-11
Paper end sensor
[ ON-OFF / ON / -]
Set whether to detect the presence of the paper.
ON: Detect the presence of the paper.
OFF: The paper is considered always exist.(Used in the test)
2-12
Drum master sensor
[ ON-OFF / ON / -]
Set whether to detect the presence of the drum master.
ON: Detect the presence of the drum master.
OFF: The drum master is considered always exist.(Used in the test)
2-13
Platen cover sensor
[ ON-OFF / ON / -]
Set whether to detect the presence of the platen cover.
ON: Detect the presence of the platen cover.
OFF: The platen cover is considered always exist.(Used in the test)
2-15
Paper length sensor
[ ON-OFF / ON / -]
Set whether to detect the presence of the paper length sensor on the master
feed unit.
ON: Detect the presence of the paper length sensor.
Always assumed to be the largest(mm:420mm, inch:432mm).
(Used in the test)
To Next Page
Loading...
