SP Table
SM Appendix 17 C279
Appendix:
Service
Program
Mode Tables
2-101
Drum Master Out&wrap Setting
[ ON-OFF / OFF / -]
This function allows users to remove and wrap the master on the drum. The
following keypad operations become available.
Remove: Press the "Reset key" for more than three seconds
Wrap: Press the "Master Making" key while pressing the "#" key.
Do not leave the drum without a master for more than a day, or the surface of
the drum will become dry.
Set whether to detect the presence of the master feed time.
OFF: Master feed time is invalid
ON: Master feed time is enable.
2-115
Reg Improvement for 1st Prt
[ ON-OFF / OFF / -]
2-120
Master Compression Time - A3
[ 0-3 / 0 / -]
2-121
Master Compression Time - B4
[ 0-3 / 0 / -]
2-122
Master Compression Time - A$
[ 0-3 / 0 / -]
2-130
5th Speed Paper Limit
[ ON-OFF / OFF / -]
This function is used to suppress printing at the 5th speed if the feed direction
length of the paper is less than 170 mm.
ON: Suppress printing at the 5th speed if the feed direction length of the
paper is less than 170 mm.
OFF: Don't suppress at the 5th speed by the paper size. The accuracy of
the image is degraded.
To Next Page
Loading...
