4.System Maintenance
137
(service switch back to "1": ON, "2": OFF) before Fiery Clone Tool begins creating an image
file.
10. Wait for the Fiery Clone Tool to create the image file.
The diagnostic LEDs circulate "b1, b2, b3" to indicate backup is in progress.
When the backup process is complete, the diagnostic LEDs flash "bC", then "00" in one
second intervals and repeats to indicate completion status.
With E-25C, it will take about 12-20 minutes to complete the backup process. The duration will
vary depending on the model and the specification of the USB flash drive models, caused by
the transfer speed specification of the USB flash drive.
If an error occurs during the backup process, the diagnostic LEDs flash "EE", then the
error code in half-second intervals. [Link to LED Error Codes Related To the Fiery Clone
Tools / Fiery System Restore]
11. While the diagnostic LEDs are flashing "bC" then "00" repeatedly, return the service switches to the
normal position ("1": OFF, "2": OFF).
12. Remove the USB flash drive from the USB port.
13. Press and release the power switch on the front panel of E-25C.
The controller will automatically move to the shutdown procedure.
14. When the E-25C power is down (that is when the diagnostic LEDs are off), turn the main power
switch of the E-25C to OFF.
15. Insert the USB flash drive to a USB port on the Windows PC.
16. In Windows Explorer, open the USB flash drive to check the files.
When a backup is created with the Fiery Clone Tool, a new folder is created on the USB flash drive,
containing the created clone image file (*.fci).
Also, history log is saved on the USB flash drive as fcte_history.log.