Ricoh MP 161 - Page 96

Send Settings
88
2
E Confirm the selected sender, and then press the {OK} key.
F To print the sender's name on the receiver's sheet, select [Stamp] using {U}
or {T}, and then press the {OK} key.
If you enable this function, the sender's name (user name) appears on the re-
ceiver's sheet, lists, and report.
G To confirm transmission results by e-mail using Internet Fax, select [E-mail]
using {U} or {T}, and then press the {OK} key.
If the sender's e-mail address is registered, you can specify whether or not to
send the transmission result by e-mail to the sender. If you enable this func-
tion, the transmission result is sent to the registered mail address.
The display returns to that of step
C
.
H Press the {Escape} key.
The standby display appears.
To check the settings, press [TX Mode].
I Specify the destination, and then press the {Start} key.