Ricoh MP 2001L User Manual

• Be sure to lift the exposure glass cover or ADF by more than 30°. Otherwise, the size of the
original might not be detected correctly.
2. Place the original face down on the exposure glass. It should be aligned with the rear left
corner.
CUA105
1
1
2
2
1. Positioning mark
2.
Left scale
• Start with the first page to be copied.
3. Lower the exposure glass cover or ADF.
• For details about how to specify the size of the originals, see page 35 "Specifying the Original
Size When a Paper Tray is Selected" or page 38 "Specifying the Original Size When the Bypass
Tray is Selected".
Placing Originals in the ADF
Settings should be made in the following situations:
• Do not stack originals over the limit mark on the side fence of the ADF.
•
The last page should be on the bottom.
• Do not cover the sensors with your hands, or place objects on them. Doing so could cause the size
to be detected incorrectly, or the paper misfeed error message to appear. Also, do not place
anything on the cover, as this too could cause a malfunction.
1. Placing Originals
34

Ricoh MP 2001L Specifications

General

Copy Resolution	600 x 600 dpi
Paper Capacity	250 sheets
Maximum Paper Size	A3
Paper Output Capacity	250 sheets
Power Source	220 - 240V, 50/60Hz
Color	Monochrome
Copy Magnification	25% - 400%
Print Speed	20 ppm
Memory	128 MB
Type	Digital
Power Consumption	1.2 kW