Safety information 10
CAUTION—PINCH HAZARD: To avoid the risk of a pinch injury, use caution in areas marked with this label.
Pinch injuries may occur around moving parts, such as gears, doors, trays, and covers.
CAUTION—POTENTIAL INJURY: This product uses a laser. Use of controls or adjustments or performance
of procedures other than those specified in the User’s Guide may result in hazardous radiation exposure.
This product is designed, tested, and approved to meet strict global safety standards with the use of specific
manufacturer's components. The safety features of some parts may not always be obvious. The manufacturer is
not responsible for the use of other replacement parts.
Refer service or repairs, other than those described in the user documentation, to a service representative.
This product uses a printing process that heats the print media, and the heat may cause the media to release
emissions. You must understand the section in your operating instructions that discusses the guidelines for
selecting print media to avoid the possibility of harmful emissions.
This product may produce small amounts of ozone during normal operation, and may be equipped with a filter
designed to limit ozone concentrations to levels well below the recommended exposure limits. To avoid high ozone
concentration levels during extensive usage, install this product in a well-ventilated area and replace the ozone
and exhaust filters if instructed to do so in the product maintenance instructions. If there are no references to filters
in the product maintenance instructions, then there are no filters requiring replacement for this product.
SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
Need help?
General