Ricoh P C200W - Tcp;Ip

Use printer menus 63
Menu item
Description
PS SmartSwitch
On*
Off*
Set the printer to switch automatically to PS emulation when a print job requires it,
regardless of the default printer language.
Note: If PS SmartSwitch is off, then the printer does not examine incoming data and
uses the default printer language specified in the Setup menu.
Mac Binary PS
Auto*
On
Off
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• On processes raw binary PostScript print jobs.
• Off filters print jobs using the standard protocol.
Energy Efficient Ethernet
Off
On
Auto*
Reduce power consumption when the printer does not receive data from the
Ethernet network.
Note: An asterisk (*) next to a value indicates the factory default setting.
TCP/IP
Note: This menu appears only in network printers or printers attached to print servers.
Menu item
Description
Set Hostname
Set the current TCP/IP host name.
Domain Name
Set the domain name.
Note: This menu item appears only in some printer models.
Allow DHCP/BOOTP to update
NTP server
On*
Off
Allow the DHCP and BOOTP clients to update the NTP settings of the printer.
Zero Configuration Name
Specify a service name for the zero configuration network.
Note: This menu item appears only in some printer models.
Enable Auto IP
On*
Off
Assign an IP address automatically.
DNS Address
Specify the current Domain Name System (DNS) server address.
Backup DNS Address
Specify the backup DNS server addresses.
Backup DNS Address 2
Backup DNS Address 3