Ricoh P C300W - Page 142

5.System Maintenance
130
Menu
Description
• Cardstock
• Envelope
• Thick Paper 1
• Thick Paper 2
2nd Front
Adjusts the transfer roller current (front
side), based on the default value.
[-15 to 15 / 0 / 1µA/step]
2nd Back
Adjusts the transfer roller current (back
side), based on the default value.
[-15 to 15 / 0 / 1µA/step]
Clear Engine Memory
Execute this to initialize a new EEPROM.
Turn the machine power off/on after you
execute this setting.
Also, the following items are cleared by
EEPROM initialization:
• Machine total counter (total page,
full color, and BW)
• Error log (listed as “Call Service” on
Maintenance Page)
• Duplex page counter
Clear Count
Resets the counter.
Reset Transfer Unit
Resets the image transfer unit life
counter.
Reset Fuser Unit
Resets the fusing unit life counter.
Reset 2nd Transfer unit
Resets the paper transfer unit (transfer
roller) life counter.
Maintenance ID
Displays the current maintenance ID
number.
Do not change this setting (DFU).
[0x00 to 0x7F / - / -]
LSU
Adjustment
Writing Unit Adj. :Bk
Sets up the LD driver parameters.
Only valid alphanumeric characters can
be input: 0 to 9, a to f, A to F.
Writing Unit Adj. :Ma
Writing Unit Adj. :Cy
Writing Unit Adj. :Ye
Unit Adj. Transfer:All
Transfers the above parameters to the
EEPROM on the EGB.
Trans. Belt Adjustment
Executes the transfer belt adjustment.