Updating the Encryption Key
You can update the encryption key and create a new key. Updates are possible when the machine is
functioning normally.
• The encryption key is required for recovery if the machine malfunctions. Be sure to store the encryption
key safely for retrieving backup data.
• When the encryption key is updated, encryption is performed using the new key. After completing
the procedure on the machine's control panel, turn off the power and restart the machine to enable
the new settings. Restarting can be slow when there is data to be carried over to the hard disk.
1. Press the [User Tools] key.
2. Press [System Settings].
3. Press [Administrator Tools].
4. Press [Machine Data Encryption Settings].
If this item is not visible, press [ Next] to display more settings.
5. Press [Update Encryption Key].
6. Select the data to be carried over to the hard disk and not be reset.
To carry all of the data over to the hard disk, select [All Data]. To carry over only the machine settings
data, select [File System Data Only]. To reset all of the data, select [Format All Data].
7. Press the [Start] key.
Encrypting Data on the Hard Disk
105
To Next Page
Loading...
