Job Log Collect Level
Level 1
User Settings
Access Log Collect Level
Level 1
Level 2
User Settings
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
3. Click [Login].
The machine administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [Logs] under "Device Settings".
5. To specify the Job Log settings, set "Collect Job Logs" to "Active"; to specify the Access Log
settings, set "Collect Access Logs" to "Active".
6. Specify the recording levels for either "Job Log Collect Level" or "Access Log Collect Level".
The settings shown for "Job Log Collect Settings Listed by Function Type" or "Access Log Collect Settings
Listed by Function Type" vary depending on the collection level selected.
If you change the setting in the list, the setting for "Job Log Collect Level" or" Access Log Collect Level"
automatically changes to [User Settings].
7. Click [OK].
8. Click [OK].
9. Click [Logout].
• The greater the Access Log Collect setting value, the more logs are collected.
Specifying log encryption
Use the following procedure to enable/disable log encryption.
1. Open a Web browser.
2. Enter " http://(the machine's IP address or host name)/" in the address bar.
3. Click [Login].
The machine administrator can log in.
Enter the login user name and login password.
Managing Log Files
125
To Next Page
Loading...
