Setting Description Setting Value
Remote Address
Specify the address of the IPsec
transmission partner. You can
also specify an address range.
The IPsec transmission partner's
IPv4 or IPv6 address.
If you are not setting an address
range, enter 32 after an IPv4
address, or enter 128 after an
IPv6 address.
Security Policy Specify how IPsec is handled.
• Apply
• Bypass
• Discard
Encapsulation Mode
Specify the encapsulation
mode.
(auto setting)
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
Select the transport mode (this
has no bearing on the security
level).
If you specify "Tunnel", you
must then specify the "Tunnel
End Point", which are the
beginning and ending IP
addresses. Set the same
address for the beginning point
as you set in "Local Address".
IPsec Requirement Level
Specify whether to only
transmit using IPsec, or to allow
cleartext transmission when
IPsec cannot be established.
(auto setting)
• Use When Possible
• Always Require
Transmission Using IPsec
171
To Next Page
Loading...
