3. Click [Login].
The network administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [Device Certificate] under "Security".
5. Check the radio button next to the number of the certificate you want to request.
6. Click [Request].
7. Make the necessary settings.
For details about the displayed and selectable items and settings, see Web Image Monitor Help.
8. Click [OK].
9. Click [OK].
"Requesting" appears under "Certificate Status".
10. Click [OK].
11. Click [Logout].
12. Apply to the certificate authority for the device certificate.
The application procedure depends on the certificate authority. For details, contact the certificate
authority.
For application details, click the Web Image Monitor Details icon and use the information shown in
"Certificate Details".
• The issuing location may not be displayed if you request two certificates at the same time. When you
install a certificate, be sure to check the certificate destination and installation procedure.
• Using Web Image Monitor, you can create the contents of the device certificate but you cannot send
the certificate application.
• Click [Cancel Request] to cancel the request for the device certificate.
Installing the Device Certificate (Issued by a Certificate Authority)
Install the device certificate using Web Image Monitor.
Use this procedure to install a device certificate issued by a certificate authority.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
3. Click [Login].
The network administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [Device Certificate] under "Security".
Using S/MIME to Protect E-mail Transmission
93
To Next Page
Loading...
