1. [Suspend / Resume] key
2. Remove the stack of paper from the finisher shift tray 2.
3. Press the [Suspend / Resume] key to restart the print.
When Using the Z-fold Function
To use the Z-fold function, you must attach the Z-fold support tray.
• You cannot attach a Z-fold support tray along with an extension output banner sheet tray attached
to the finisher Shift Tray 1.
Finisher/booklet finisher
• Finisher shift tray 1 or 2
Attach the Z-fold support tray by inserting the two protrusions on its underside into the holes
on the finisher shift tray 1 or 2.
If you switch the output tray to eject paper while specifying [Enable] on the [Settings] hub
[Printer Settings] [Settings of Output Tray] [Shift Tray Settings] [Unlimited paper output],
and also [Not stacked] in [Stack Jobs] when the Z-fold support tray is attached, the output
paper may be stacked on the same output tray.
Special Notes When Using External Options
31
To Next Page
Loading...
