4. Select the method of overwriting.
NSA
[NSA] [Erase]
DoD
[DoD] [Erase]
Random Numbers
[Random Numbers] [Number of Erase] Enter the number of times that you want to
overwrite [OK] [Erase]
5. Press [Yes].
The printer restarts automatically, and then overwriting starts.
6. When overwriting is completed, press [Exit], and then turn off the main power.
Before turning the power off, see “Turning On/Off the Power”, Operating Instructions.
• If the main power switch is turned off before "Erase All Memory" is completed, overwriting will start
over when the main power switch is turned back on.
•
If an error occurs before overwriting is completed, turn off the main power. Turn it on again, and
then repeat from Step 2.
Suspending Erase All Memory
The overwriting process can be suspended temporarily.
• Erase All Memory cannot be canceled.
1. Press [Suspend] while Erase All Memory is in progress.
2. Press [Yes].
Erase All Memory is suspended.
3. Turn off the main power.
Before turning the power off, see “Turning On/Off the Power”, Operating Instructions.
• To resume overwriting, turn on the main power.
Deleting Data on the Hard Disk
101