4040+e_22.docx / 06.10.17
ROBERT RIELE GmbH & Co KG Page 57 8- UTILITY PROGRAMS
8.2.8 Stored results
[EXIT] terminates the program.
[SHOW] indicates stored data step by step.
[SEND] transmits stored results through the
serial port.
After transmitting is completed you will be
prompted to delete stored results. Press
[START] to delete results or [EXIT] to exit
without deleting results.
The current status of the heating is indi-
cated in the first line by OFF or ON.
Change setting by [SELECT].
Save setting permanently by [OK].
Save setting temporarily up to next switch-
off of the device by [EXIT].
The name of the laboratory can be stored
permanently.
In case of a stored name an additional line
within the header is sent to the printer or to
the EDP.
By [NEW] the entry of the laboratory name is
possible.
Enter the laboratory name via the alphanu-
meric keyboard.
Following functions are available:
[a/1] : change to lowercase
[1/A] : change to numeric characters
[A/a] : change to uppercase
[] : delete character
[] : blank
[ESC] : finish input without storage
[ENT] : finish input with storage
H E A T I N G O N
E X I T O K S E L E C T
L A B O R A T O R Y N A M E
E X I T N E W
U T I L I T I E S P A G E 3 / 5
N E W L A B O R A T O R Y N A M E
<
Q W E R T Y U I O P
A S D F G H J K L
E S C Z X C V B N M A / 1 E N T
S T O R E D R E S U L T S
A C T U A L 5
E X I T S H O W S E N D
To Next Page
Loading...
