Riello GITRE Series - Moving and Removing the Packing

15
INSTALLATION
2.3 Moving and removing the packing
9
If the installation involves a lot of moving (e.g. to a rooftop
or cellar utility room) do not remove the protective wooden
cage until the boiler is at its place of installation.
9
Wear suitable personal protection equipment when moving
the boiler and removing the packing. Only use lifting equip-
ment that is suitable for the weight involved.
Proceed as follows to remove the packing:
− Remove the staples (A) xing the wooden cage (1) to the
pallet
A
1
− Lift off the wooden cage (1) or slide it off to the rear. (Pull
out the staples (B) and remove the front of the cage rst
in order to slide it off to the rear.)
B
1
− Remove the polystyrene edge protectors (2)
− Pull off the protective bag (3).
2
3
0
Do not dispose of packaging material into the environment,
or leave it within the reach of children, since it can become
a potential hazard. Dispose of packaging material in com-
pliance with applicable legislation.
With the packing removed, remove the front panel (1).
1
Locate the bag containing the documentation, remove the en-
ergy label and apply it to the boiler casing.
25 kW
30 mm
25 mm