Rigol DP800 Series User Manual

RIGOL Chapter 2 Front Panel Operations
2-16 DP800 User’s Guide
2. Read
Press Read to enter the store and recall interface, the file type is fixed at “*.rtf”
and please read the desired file according to the introduction in “
Store and
Recall”. Users can edit the timer file read.
To Enable the Timer
After setting the timer parameters, press Timer  Timer to enable the timing
output. The timing output interface is as shown in the figure below.
Figure 2-2 Timing Output Interface
Tip
 Enabling the timer will change the output value of the channel; make sure
that the change in the output value will not affect the device connected to
the power supply before enabling the timer.
 The timing output is valid only when both the timer and the channel output
are turned on.
 When the timer is enabled, the timer parameters cannot be modified and
Delayer is grayed out and disabled.

Rigol DP800 Series Specifications

General

Brand	Rigol
Model	DP800 Series
Category	Power Supply
Language	English