RIGOL Chapter 3 Remote Control
3-2 DP800 User’s Guide
Remote Control via USB
1. Connect the device
Connect the USB DEVICE interface at the rear panel of the power supply with
your PC using a USB cable.
2. Install the USB driver
This power supply is a USB-TMC device. Assuming that your PC has already been
installed with Ultra Sigma, after you connect the power supply to the PC and
turn both on for the first time (the power supply is automatically configured to
USB interface), the New Hardware Wizard as shown in the figure below is
displayed on the PC. Please install the “USB Test and Measurement Device”
driver following the directions in the wizard. The steps are as follows.
To Next Page
Loading...
Need help?
General
