Rigol DP800 Series User Manual

Chapter 2 Front Panel Operations RIGOL
DP800 User’s Guide 2-45
instrument will load the server address set automatically at the next power-on if
DHCP and Auto IP are set to “Off”.
9. Default
Press Def Cfg and the prompt message “Restore LAN to default?” will be
displayed; press OK to restore the network parameters to default values. At this
point, the DHCP and auto IP configuration modes are enabled and the manual
IP configuration mode is disabled.
10. Current Setting
Press Cur Cfg to view the MAC address, current network parameters and
network status information of the instrument.
11. Apply the Setting
Press Apply to apply the network parameters currently set.

Rigol DP800 Series Specifications

General

Brand	Rigol
Model	DP800 Series
Category	Power Supply
Language	English