RIGOL
2-72 © Copyright RIGOL Technologies, Inc. 2007.
User’s Guide for DS1000 Series
Factory
The oscilloscope has default settings and can be recalled at anytime by user.
Memory location
Specify the memory location to save/recall the waveform and setup.
Load
Recall saved waveform, setup and default settings.
Save
Save waveform and setups.
NOTE:
1. Select Save stores not only the waveforms, but also the current settings of
the oscilloscope
2. Only after the settings are changed for more than 5 seconds can the user turn
off the instrument. This ensures the setup be saved properly. The oscilloscope can
store 10 settings permanently and can restore at anytime.
To Next Page
Loading...
