RIGOL
© Copyright RIGOL Technologies, Inc. 2007. VII
User’s Guide for DS1000 Series
Content
Safety Notices ..................................................................................................II
General-Purpose Oscilloscopes .......................................................................... V
CHAPTER 1: GETTING STARTED..................................................................... 1-1
The Front Panel and the User Interface ....................................................... 1-2
To Inspect the Instrument .......................................................................... 1-6
To Perform a Functional Check.................................................................... 1-7
To Compensate Probes............................................................................... 1-9
To Use Digital Leads (Mixed Signal Oscilloscope) ........................................ 1-10
To Display a Signal Automatically .............................................................. 1-12
To Set Up the Vertical Window.................................................................. 1-13
To Set Up the Horizontal System ............................................................... 1-15
To Trigger the Oscilloscope....................................................................... 1-17
CHAPTER 2: OPERATING YOUR OSCILLOSCOPE .............................................. 2-1
Understand the vertical system ................................................................... 2-2
Understand the Horizontal System............................................................. 2-30
Understand the Trigger System................................................................. 2-36
To Set Up the Sampling System ................................................................ 2-59
To Set Up the Display System ................................................................... 2-63
To Store and Recall Waveforms or Setups.................................................. 2-65
To Set Up the Utility ................................................................................. 2-73
To Measure Automatically......................................................................... 2-91
To measure with cursors........................................................................... 2-98
To use run control buttons.......................................................................2-105
CHAPTER 3: APPLICATION & EXAMPLES ......................................................... 3-1
Example 1: Taking Simple Measurements..................................................... 3-1
Example 2: View a signal delay caused by a circuit ....................................... 3-2
Example 3: Capture a Single-Shot Signal...................................................... 3-3
Example 4: To reduce the random noise on a signal...................................... 3-4
Example 5: Making Cursor Measurements .................................................... 3-6
Example 6: The application of the X-Y operation........................................... 3-8
Example 7: Triggering on a Video Signal .................................................... 3-10
Example 8: FFT Cursor measurement ........................................................ 3-12
To Next Page
Loading...
