RIGOL
1-10 © Copyright RIGOL Technologies, Inc. 2007.
User’s Guide for DS1000 Series
To Use Digital Leads (Mixed Signal Oscilloscope)
1. Switch off power supply of the Device Under Test if necessary to avoid short
circuit. Since no voltage is applied to the leads at this step, you may keep the
oscilloscope on.
2. Connect one end of the flat cable FC1868 to the Logic Analyzer Input, connect
the other end to Logic Head LH1116. An identifier is located on each end of the
flat cable, it can only be connected in one way. It is unnecessary to switch off
power supply of your oscilloscope connect the cable.
Figure 1-10
CAUTION: Use only FC1868, LH1116, TC1100 and LC1150 made by
RIGOL for specified mixed signal oscilloscopes.
!
To Next Page
Loading...
