Rigol DS6062-DEMO - To Enable REF Function

RIGOL
DS6000 User’s Guide
8-2
To Enable REF Function
Press the REF function key in the vertical control area (VERTICAL) at the front panel
to enable REF function. Note that when the time base is in X-Y mode, REF function
can not be enabled.
DS6000 provides 10 reference waveform channels. Press Channel and use to
select to turn the desired reference channel on or off and a channel icon of the
channel that is turned on will be display at the left side of the screen grid. For
example: .
When REF function is enabled, you can set the source of each reference channel,
adjust the vertical scale and position of the reference waveform and save the
reference waveform to internal or external memory as well as recall it when needed.
For details, please refer to the introduction below.
REF