Rigol DSA815 - Device Specific Error

RIGOL Chapter 4 Troubleshooting&Message
User’s Guide for DSA800/E Series
4-16
Device Specific Error
Number Message Description
-300
Device-specific error.
A generic device-dependent error indicates that the device cannot detect
more specific errors. This code indicates that only a Device-Dependent
Error defined in IEEE 488.2, 11.5.1.1.6 has occurred. Please report the
error to your
RIGOL
sales or technical support team.
-310 System error.
Indicate that some error, termed “system error” by the device, has
occurred. Please report the error to your RIGOL sales or technical
support team.
-311
Memory error.
Indicate that local C disk is not formatted or an error occurred during
self-test. If restarting the device is still of no effect, please report the
error to your
RIGOL
sales or technical support team.
-314
Save/recall memory lost.
Indicate that the nonvolatile data saved by the *SAV? command has been
lost.
-315 Configuration memory lost.
Indicate that nonvolatile configuration data saved by the device has been
lost.
-321 Out of memory.
An internal operation needed more memory than that was available.
Please report the error to your
RIGOL
sales or technical support team.
-330 Self-test failed.
The self-test failed. For more information, please refer to the result of the
Self-test.
-340 Calibration failed.
The calibration failed. Please report the error to your RIGOL sales or
technical support team.
-350
Queue overflow.
Error occurs when the code enters into the queue. This message
indicates that there is no room in the queue and an error occurred but
was not recorded.
-360 Communication error.