Rigol RSA3000E Series User Manual

Chapter 4 Functions of the Front Panel of EMI RIGOL
RSA3000E User Guide 4-11
Sweep
Sets the sweep-related parameters.
Frequency Scan
Sets the current frequency scan mode to "Single" or "Cont".
Start/Stop
Selects "Start" to start pre-scan, peak search, or the final measurement according to
the selected frequency scan mode.
Selects "Stop" to stop the current scan, search, or measurement.
Pause/Resume
Selects "Pause" to pause the current pre-scan, peak search, or final measurement
operation. Note, the pause operation can be executed only within the two scan
ranges.
Selects "Resume" to resume scan, search, or measurement and start the operation
from the scan point where you pause.
Clear List and Start
After you press or tap this menu, all the signals in the signal table will be cleared.
Then, the selected scan sequence will be launched. If the selected scan sequence is
being scanned and is in the Cont scan mode, you need to select "Stop" under the
Start/Stop menu to stop scan. In other conditions, when the measurement is
completed, the scan sequence is stopped automatically.
Continue(Meter)
Sets the measurement mode of the meter to Continuous. Only when you set the
current setting to Single scan mode or restart to launch the scan sequence, can the
measurement be stopped.

Rigol RSA3000E Series Specifications

General

Brand	Rigol
Model	RSA3000E Series
Category	Measuring Instruments
Language	English