Chapter 5 Functions of the Front Panel of VSA RIGOL
RSA3000E User Guide 5-43
Peak
The peak search function enables the marker to move to the specific signal peak
point, and then in combination with the function of Delta marker, it can provide a
powerful analysis capability.
Peak Search
Performs the peak search function. Searches for the maximum value on the trace and
marks it with a marker.
Next Peak
Searches for and marks the peak whose amplitude on the trace is next lower than
that of the current peak.
Next Higher
Searches for and marks the peak whose amplitude on the trace is next higher than
that of the current peak.
Next Peak Right
Searches for and marks the peak closest to the right side of the current peak.
Next Peak Left
Searches for and marks the peak closest to the left side of the current peak.
Minimum Search
Searches for and marks the peak with the minimum amplitude on the trace.
Cont Peak
Enables or disables continuous peak search. By default, it is Off. When it is enabled,
after finishing each sweep, the analyzer will automatically execute one peak search
operation to track the measurement signal.
To Next Page
Loading...
Need help?
General
