Rion VM-83 - Accelerometer Installation Methods

64
Serial Interface
STS? Get setting information
Output data format
p1 p2 p3 p4 p5 p6 p7 p8 p9 p10<EOT><CR><LF>
p1 : INPUT SELECT 0 to 4
p1 = 0 : ACCELEROMETER in-
put
p1 = 1 : PREAMP 1 input
p1 = 2 : PREAMP 2 input
p1 = 3 : SERVO input
p1 = 4 : SERVO input
p2 : Level range 0 to 7 (RNG n)
p3 : Measurement mode 0 to 2 (UNT n)
p4 : Display characteristics 0 to 2 (DET n)
p5 to p8 : Sensitivity (SNS n1 n2 n3 n4)
p9 : High-pass filter setting (HPF n)
p10 : Low-pass filter setting (LPF n)
For information on value in brackets, refer to sections on
respective commands.