Rion VM-83 - Page 75

65
Serial Interface
Allowable remote mode commands in various operation conditions
 indicates that command is allowed (valid).
× indicates that command is not allowed (invalid).
Command
Normal
Calibration Comparator
Maximum Peak DOF
Explanation
measurement hold hold operation
RMT n1n2n3 Cancel remote mode
RMT?  ×××××
RNG n  ×××××Level range
UNT n  ×××××Measurement mode
DET n  ×××××Display characteristics
SNS n1 to n4  ×××××Set sensitivity
LPF n  ×××××Low-pass filter
HPF n  ×××××High-pass filter
CAL n  × × × × Calibration setting
CAL?  ××××
BAT?  ×××××Battery status
DOD?  × × Measurement value
DOF n  ××××(DOF0)
Instantaneous value
(100 ms)
MAX n  ××(MAX0) × × Maximum hold
MAX?  ×× ××
PEK n  ×××(PEK0) × Peak hold
PEK?  ××× ×
RST × × × Reset
CMP n  × (CMP0) × × × Comparator
CMP?  ×  ×××
CMS n1 to n7  ×××××Comparator setting
CMS?  ×××××
STS?  ×××××Setting information