Rittal 7844440 - Page 15

Page 15 DCN 4727 REV 6 Doc No. C29115
• No lateral movement of the rack against rotation of castors, i.e. dragging fixed castors.
Failure to follow these instructions can result in death, serious injury or equipment
damage.
Statement 6
In regards to levelling the rack on feet the following warnings must be upheld:
WARNING
TIP / HEAVY EQUIPMENT
• This rack is easily tipped. Use extreme caution when handling
• Instructed or Skilled persons to handle rack only.
• People handling the rack must wear PPE in accordance with local risk assessments and local
regulations.
• Levelling feet cannot compensate for a badly sloped floor surface.
• Levelling feet must be deployed equally (5mm increments maximum per levelling foot)
• Levelling feet must be fully extended to the floor
• The full weight of the rack rests on the levelling feet.
• Rack must be bolted down using kit 7844246 only if a single-rack installation.
• If joining to adjacent racks, ensure adjacent rack is at the same level.
Failure to follow these instructions can result in death, serious injury or equipment
damage.
Statement 7
In regards to bolting down the rack to the data centre floor, the following warnings must be upheld:
WARNING
TIP / HEAVY EQUIPMENT
• This rack is easily tipped. Use extreme caution when handling.
• Instructed or Skilled persons to handle rack only.
• People handling the rack must wear PPE in accordance with local risk assessments and local
regulations.
• Rack must be bolted down using kit 7844246 only.
Failure to follow these instructions can result in death, serious injury or equipment
damage.
Statement 8
In regards to baying / joining a rack to another rack, the following warnings must be upheld:
WARNING
TIP / HEAVY EQUIPMENT
• This rack is easily tipped. Use extreme caution when handling.
• Joining racks provides limited stability to the racks.
• Instructed or Skilled persons to handle rack only.
• People handling the rack must wear PPE in accordance with local risk assessments and local
regulations.
Failure to follow these instructions can result in death, serious injury or equipment
damage.