RKI Instruments GD-70D Series User Manual

- 79 - GD-70D
SET 19.PUMP CK
Set the pump drive level
diagnosis.
Select either ON or OFF, and
then press the SET key to
confirm the selection.
When ON is selected, the
message "FLOW" is
displayed if the flow rate is
sufficient even though the
pump drive level is low. (A
function to check the
conditions for applying
pressure, etc.)
●
○
○
○
SET 19
PUMP CK
MAINTENANCE
⇔
SET
ON
PUMP CK
MAINTENANCE
▲↓ ↑▼
▲
↓↑
▼
OFF
PUMP CK
MAINTENANCE
To
SET 0. ADDRESS
9-5 Date/Time Setting "2-10" - "SET 1"
Date/Time Setting
PW
A1
A2
F
LCD
From Detection Mode, press and hold
the MODE key for three seconds.
●
○
○
○
0.0ppm
SIH4
↓
↓
1-8.M MODE
Press the ▲ key until the Maintenance
Mode screen displays. (For GD-70D-EA
units, the Maintenance Mode screen is
item 1-9.)
●
○
○
○
1- 8
M MODE
MAINTENANCE
↓
↓
User Mode
In "1-8.M MODE", press the SET key.
●
○
○
○
1- 8
M MODE
MAINTENANCE
↓
↓
Then press and hold the SET key again
for three seconds.
●
○
○
○
- - - -
M MODE
MAINTENANCE
↓
↓
2-0.GAS TEST
The first item in Maintenance Mode will
display.
●
○
○
○
2- 0
GAS TEST
MAINTENANCE
↓
↓
2-10. SETTING2
Press the ▲ key until the SETTING2
screen displays.
Press the SET key.
●
○
○
○
2- 10
SETTING2
MAINTENANCE

RKI Instruments GD-70D Series Specifications

General

Brand	RKI Instruments
Model	GD-70D Series
Category	Gas Detectors
Language	English