Rockwell Automation 1768-L43 - Add Distributed I;O Modules

Publication IASIMP-QS003B-EN-P - October 2009 117
Add Distributed Point I/O Modules to the Project Chapter 10
Add Distributed I/O Modules
Required for EtherNet/IP System
1. Verify that your project is
offline.
2. Right-click 1768-ENBT
under 1768-Bus and
select New Module.
3. Expand
Communications.
4. Select the 1734-AENT
adapter and click OK.
5. Select the appropriate
major Revision (HW rev)
recorded in Appendix
A
and click OK.